Diver equipment vehicle – “Diver”

The diving equipment vehicle combines the highest quality with innovative technology and is specially tailored to the requirements of water rescue. In addition, we offer you the opportunity to customize the vehicle to suit the intended purpose with a wide range of optional equipment.

Highlights

Trough-shaped spray floor – Specially for the requirements of water rescue
Safe accommodation – Tested safety solutions for material and equipment
Impregnated interior components and perfected surfaces for water rescue
Diving equipment holder with release and coupling mechanism to US military standard – Teflon-impregnated and seawater-resistant
Pull-out enables ergonomic and back-friendly mounting of the diving equipment

Standard equipment

Base vehicle

Mercedes-Benz Sprinter long L3H2 (wheelbase 4,325 mm, high roof)
All-wheel drive (4×4)
incl. complete ceiling cladding
Genuine Mercedes-Benz roof air conditioner
permissible. Total weight: 5.0/ 5.5 tons

Exterior

230 volt external power supply DEFA
LED ambient lighting Track 40, arranged 2x left and 2x right
2 x Track 40 rear position lights
Mechanical door-combined step Side entry

Interior driver's compartment

Driver’s compartment cabinet graphite black
Spotlight above front passenger
Half-height partition wall behind driver/co-driver to accommodate electrical components etc.
INOMATIC control units in body cover
230 volt surface-mounted socket for charger

Interior of crew/equipment room

4 comfort seats with adjustable headrest, black imitation leather cover, seat arrangement 2x in the direction of travel, 2x against the direction of travel
Brackets for 1 Euro-Fix box (400x300x200 mm) under comfort seats facing against the direction of travel
Entry handle with reinforcement on C-pillar
Auxiliary heater with step protection cover for air vents in the crew compartment
Heat deflector plate on left side wall paneling
Spray floor dark gray/light gray, tub-shaped for water rescue vehicles
Drainage channel with drain pipe integrated in the spray floor
ABS interior trim
Shelving systems left and right for holding Euroboxes incl. pull-out for diving equipment
Bracket for diving equipment: Seawater-resistant bracket for holding diving equipment with a coupling mechanism
Spineboard Combi Carrier II holder
Hand-held fire extinguisher with holder
3 recessed LED lights in the crew and equipment room
3 USB-C/A double sockets

Signaling technology

Roof beams
Front flasher
Tone sequencer with compressor simulation
3rd rear beacon, can be switched off separately

Electrics

Battery charger for starter and auxiliary battery
Charging booster, intelligent charging management
230 volt central distribution board with residual current circuit breaker (RCCB) and potential equalization
12 Volt central electrics

Radio/communication technology

Radio antenna for digital radio TETRA/GPS
Installation of SIM card reader provided including SiKaPlug mounting unit, integrated in the center console
Radio interference suppression filter
Radio master switch with time relay
Radio loudspeaker integrated in ceiling
Installation of supplied digital radio with hand-held control unit in the center console in the driver’s compartment
MRT programming interface in the center console
Digital hands-free kit with gooseneck PTT switch box
Installation and connection of the HRT charging cradle provided

Basic/bodywork

Body protection:

Cavity preservation: Reinforced cavity sealing offers the best corrosion protection and increases the service life of water rescue vehicles by several years
Underbody protection: coating of the entire underbody with a permanently elastic off-road underbody protection

Equipment options

Exterior

Additional ambient light left and right
Working lights instead of Track40 at the rear
Flag holder
Branch deflector for signal system/Martin flutes on the roof
Ventilator on the roof
230 volt external power supply RETTBOX
WARN cable winch with cable winch mounting kit
Awning with awning front box

Interior driver's compartment

USB-C/A socket

Interior of crew/equipment room

Airline rails on the backs of the left and right shelves, including fitting and tensioning strap with ratchet
Hand-held spotlight with charging station
Hygiene module consisting of: Eyewash bottle, hand brush; soap dispenser, 5 liter water canister with tap, towel dispenser with wipes, 3-fold glove dispenser, arrangement: rear door
Holder for helmets
Airline rails arranged on the floor between the two shelving systems, including fitting and tensioning strap with ratchet
12 volt power socket
LED recessed light with night lighting (in red, green or blue)
Removable table, arrangement when not in use: on the front right shelf or rear wall partition
Holder for telescopic ladder